Calculations Included:
(Click To See Graphics)
 

1. 90 Degree Offset
2. 45 Degree Offset Factory Fittings
3. You Pick the Degree of Offset You Want (Mitered Fittings)
4. You Pick the Set and Run
5. 45 Degree Fitting to Fitting Offset (Factory Fittings)
6. Fitting to Fitting, You Pick the Degree of Fitting
7. Fitting to Fitting Offset, You Pick the Set
8. You Pick the Set and Run
9. 90 Degree Ell and Fitting of Your Choice, You Pick the Set
10. Fitting to Fitting Offset With 90 Degree Ell and Unknown Miter Fitting
11. Offset With 90 Degree Ell and Mitered Fitting Where the Pipe or Fitting Cannot Be Moved
12. Offset Where Piping is Set and Cannot Be Moved or Cut
13. Offset Where Piping is Set at Right Angles and Cannot be Moved or Cut
14. Rolling Offset With 90 Degree Ell
15. Rolling Offset With 45 Degree Ell (Factory Fittings)
16. Rolling Offset, You Pick the Degree of Fitting
17. Rolling Offset With Mitered Fittings
18. Compound Rolling Offset, Horizontal To Vertical
19. Compound Rolling Offset, Horizontal To Horizontal
20. Squaring a 90 Degree Offset With Any Measurement
21. Squaring Any Degree Offset With Any Measurement
22. Inside and Outside Measurements to Miter a Fitting


All calculations are designed for long radius butt weld fittings.

Contact:
Provision Construction Concepts, Inc.
2410 Cerca Madera
San Antonio, TX 78259
(210) 413-8550

General Inquiries:
Sales@americanpipefitter.com

Technical Support:
Support@americanpipefitter.com


Home  Calculations  PDA's  PDA Accessories  Instructions  Our Story  Contact Us

2007 Provision Construction Concepts, Inc.  -  AmericanPipefitter.com  //  All Rights Reserved  //  Site by
Strottner Designs